One of the two essential elements of mixer plays an important role. So, what conditions do concrete mixers need to have?

一、混凝土搅拌机应该设置在平坦的地方，让轮胎处于悬空位置，以免在开工时发生松动。在搅拌前进行空车试运转，做好准备工作。需要注意的是，试运转时应检验拌筒转速是否合适，一般情况下，空车速度比装料后稍快2-3转，如相差较多，应调整动轮与传动轮的比例。

1、 The concrete mixer should be set in a flat place, so that the tires are in the suspended position, so as to avoid loosening when starting. Before mixing, the empty car test run shall be carried out and the preparation work shall be done. It should be noted that the speed of mixing drum should be checked during commissioning. In general, the speed of empty car is slightly faster than that after loading. If there is a large difference, the ratio of driving wheel to driving wheel should be adjusted.

二、在混凝土搅拌机工作前要认真检查各个零部件，看看传动离合器和制动器是否灵活可靠，钢丝绳有无损坏，轨道滑轮是否良好，周围有无障碍及各部位的润滑情况等。确认没问题后再进行开机。

2、 Before the concrete mixer works, carefully check all parts and components to see whether the transmission clutch and brake are flexible and reliable, whether the steel wire rope is damaged, whether the track pulley is in good condition, whether there are obstacles around and the lubrication of various parts. After confirming that there is no problem, start the machine again.

三、如果在开机过程中，如果发现电器或者机械故障时，应该卸出余料，等故障排除后再开机运转。当然，在使用时，要经常检查，防止事故的发生。

3、 If in the start-up process, if electrical or mechanical failure is found, the surplus material should be unloaded, and the machine can be started up after the fault is eliminated. Of course, in the use, we should often check to prevent the occurrence of safety accidents.

四、混凝土搅拌机使用完毕后，拉闸断电，锁好开关控制箱，要记得按时清理，打扫场地卫生，让机械保持清洁。

4、 After the concrete mixer is used, switch off the power and lock the switch control box. Remember to clean up on time, clean the site and keep the machinery clean.

以上就是小编为大家介绍的关于混凝土搅拌机的相关内容，希望可以帮助到大家，更多精彩内容请关注：http://www.zkhntjbc.com

The above is about the concrete mixer introduced by the small editor. I hope it can help you http://www.zkhntjbc.com