There are three ways to settle the mixing drum of the forced concrete mixer on the chassis of the car. One is that the mouth of the drum is slanted towards the rear of the car, and the concrete is loaded and unloaded from the rear of the car; The other is that the mixing drum is tilted forward, and the material is loaded and discharged in front of the mixing drum; There is also an inclined mixing drum which can rotate the whole car. During this period, the mixing drum is tilted back to settle down, which has many structural methods and sophisticated technology.

前倾式有驾驶员操作方便之利，但搅拌筒口有必要逾越驾驶室上方，使搅拌筒过长过高，并使组织杂乱，搅拌筒容积利用率也有所下降，惯例设计一般选用搅拌筒后倾安顿。

The forward tilt type has the advantage of convenient operation for the driver, but it is necessary for the mouth of the mixing cylinder to go beyond the top of the cab, so that the mixing cylinder is too long and too high, and the organization is disordered, and the volume utilization rate of the mixing cylinder is also reduced. The conventional design generally selects the backward tilt of the mixing cylinder to settle down.

开机后，常常注意混凝土搅拌机http://www.zkhntjbc.com各部件的运转是否正常。停机时，常常查看混凝土搅拌机叶片是否打弯，螺丝有否打落或松动。当混凝土搅拌结束或估量停歇1h以上，除将余料出净外，运用石子和清水倒入抖筒内，开机转动，把粘在料筒上的砂浆冲刷干净后悉数卸出。料筒内不得有积水，以免料筒和叶片生锈。

After starting the machine, always pay attention to the concrete mixer http://www.zkhntjbc.com Whether the operation of each component is normal. When the machine stops, often check whether the blade of concrete mixer is bent, and whether the screw is broken or loose. When the concrete mixing is finished or the estimated stopping time is more than 1 hour, in addition to discharging the remaining materials, use stones and clean water to pour into the shaker drum, turn on the machine, wash the mortar adhered to the drum, and then discharge all the mortar. There shall be no water in the barrel to prevent the barrel and blade from rusting.

运用此类配料机的用户为降低收购本钱，多期望借用配料机的计量斗来一同计量散装水泥，通过水泥螺旋输送机将水泥仓中的水泥打入配料机计量斗，一般不主张此用法，因为水泥流动性好，会形成计量斗口与输送皮带空隙有少量水泥溢出，而形成现场粉尘污染或水泥丢失，如非要运用此方法则有必要选用槽型皮带托辊，且斗口边加设软薄挡边，方能控制水泥外溢。

In order to reduce the purchase cost, users of this kind of batching machine often expect to use the metering bucket of batching machine to measure bulk cement together, and drive the cement in the cement bin into the metering bucket of batching machine through cement screw conveyor. This usage is generally not advocated, because the cement has good fluidity, which will form a gap between the metering bucket mouth and the conveyor belt, and a small amount of cement spills, If it is necessary to use this rule, it is necessary to select trough belt idler, and set soft thin edge at the bucket mouth to control the cement overflow.