The number of batching errors in the equipment of the concrete mixing plant directly affects the quality of the concrete produced by the mixing plant, so how to control the batching errors in the mixing plant is particularly important.

今天为您介绍混凝土搅拌站中配料差错调整程序的办理，以下是具体内容：

Today, I will introduce to you the handling of batching error adjustment procedures in concrete mixing plant. The following are the specific contents:

1、每天混凝土生产前，由实验人员测定砂、石料含水量，核算施工合作比，填写告诉单，交给搅拌站操作人员并办理签收手续。

1. Before concrete production every day, the laboratory personnel shall measure the water content of sand and stone, calculate the construction cooperation ratio, fill in the notice, submit it to the operator of the mixing plant and go through the signing procedures.

2、由混凝土搅拌站操作人员按照告诉单的各项参数，输进操作操控器，经实验人员复核断定，然后确定，所确定的参数任何人不得更改。

2. The operator of the concrete mixing plant shall input the parameters into the operation controller according to the parameters in the notice, which shall be rechecked and determined by the experimental personnel, and the determined parameters shall not be changed by anyone.

3、投料拌合后，操作人员查看核对各资料的实际计量数据，是否与设定的参数相符，是否在规则的差错规模内，如不在其规模内，由操作人员对计量体系进行微调差错规模。每次差错调整，操作人员应做好具体调整记载。

3. After feeding and mixing, the operator shall check whether the actual measurement data of each data is consistent with the set parameters and within the regular error scale. If not, the operator shall fine tune the measurement system to the error scale. For each error adjustment, the operator shall make specific adjustment records.

4、混凝土搅拌站设备实验人员每个星期进行一次配料差错剖析，查看主动计量体系的波动情，写出书面差错剖析报告。

4. The equipment laboratory personnel of the concrete mixing plant shall analyze the batching error once a week, check the fluctuation of the active metering system, and write a written error analysis report.

5、混凝土搅拌站设备实验人员将剖析成果告诉搅拌站操作人员，差错有些超出规则规模，操作人员应对计量体系进行调整。

5. The equipment experimenters of the concrete mixing plant told the mixing plant operators of the analysis results. Some errors were beyond the scale of the rules, and the operators should adjust the metering system.

6、差错超出严重，或都不在规则规模内，告诉厂家进行修理调试达到标准。

6. If the error is serious or not within the regular scale, tell the manufacturer to repair and debug until it meets the standard.