如今小型搅拌机的使用频率是越来越高了，很多购买搅拌机的人对于如何选购搅拌机还是有些模糊的，今天我们就来说说搅拌机的选购点——动力匹配，这对车辆来说是非常重要的，动力匹配的好，车辆的性能才能发挥很好，做起事来才能事半功倍。

Nowadays, small mixers are used more and more frequently. Many people who buy mixers are still vague about how to purchase mixers. Today, let's talk about the selection point of mixers - power matching, which is very important for vehicles. Only good power matching can give full play to the vehicle's performance and do things with half the effort.

1、发动机马力的选择，对于同一企业的发动机，马力越大，加速性能越好，爬坡性能越好、重载时高车速越大，运行时换挡的次数越少。因此如果想要你的搅拌机加速快，爬坡性能好，车速高，减少换挡次数，那就好选择相对马力较大的发动机，说的相对就是适当的，不能是马力太大，那就会造成浪费的。

1. For the selection of engine horsepower, for engines of the same brand, the higher the horsepower, the better the acceleration performance, the better the climbing performance, the higher the high speed under heavy load, and the less the shift times during operation. Therefore, if you want your mixer to accelerate fast, have good climbing performance, have high speed, and reduce the number of gear changes, you should choose an engine with relatively high horsepower. That's appropriate. It can't be that the horsepower is too high, which will cause waste.

2.变速箱选择，一般来说档的位数越多，1档时爬坡性能越好，档位数越多，换挡时发动机转速变化月小，整车的使用就更加经济省油；变速器扭矩，变速器的额定输入扭矩不能小于发动机的大扭矩。

2. For gearbox selection, generally speaking, the more the number of gears, the better the climbing performance at first gear, the more the number of gears, and the smaller the monthly change of engine speed when shifting, the more economical and fuel efficient the use of the whole vehicle; Transmission torque. The rated input torque of the transmission shall not be less than the large torque of the engine.

3.车辆后桥的选择，搅拌机的承载力主要依靠后桥，后桥的速比月小，同等条件下高车速越高，经济车速越高，经济车速越高，车辆就越省油，但是车辆的爬坡就差点，高档加速能力就差些。

3. The selection of the rear axle of the vehicle and the bearing capacity of the mixer mainly depend on the rear axle. The speed ratio of the rear axle is small in months. Under the same conditions, the higher the high speed, the higher the economic speed, and the higher the economic speed, the more fuel efficient the vehicle will be. However, the climbing ability of the vehicle is poor, and the high-end acceleration ability is poor.

4.单双级强的选择，单级桥只有主减速器一对齿轮啮合，传动效率高，省油；双级桥有主减和轮边减速两对齿轮啮合，传动效率低，但是半轴上扭矩小，可靠性比较高。

4. Single and double stage strong selection. The single stage axle only has a pair of gears engaged in the main reducer, with high transmission efficiency and fuel saving; The two-stage axle has two pairs of gears, the main reducer and the wheel side reducer, which are engaged. The transmission efficiency is low, but the torque on the axle shaft is small and the reliability is high.

5.动力总成选择，大功率发动机+直接档+小速比的优势：大功率换挡减少，保证小型搅拌机的发动机工作在经济转速区，爬坡动力强；直接换挡变速器+小速比后桥可以实现和超速档变速器+大速比后桥相同的小传动比，两种配置经济车速一致；直接档啮合齿轮数量较少，传动效率较高，节油性好。

5. Powertrain selection, advantages of high-power engine+direct gear+small gear ratio: reduce high-power gear shifting, ensure that the engine of small mixer works in the economic speed zone, and have strong climbing power; The direct shift transmission+small gear ratio rear axle can achieve the same small transmission ratio as the overdrive transmission+large gear ratio rear axle, and the two configurations have the same economic speed; The number of direct gear meshing gears is small, the transmission efficiency is high, and the fuel economy is good.

6.一般情况下经常使用高档行驶的搅拌机，建议使用直接档+小速比配置；经常使用次高档行驶的搅拌机，好使用超速档+大速比配置。

6. Generally, high-grade mixers are often used, and it is recommended to use direct gear+small speed ratio configuration; Always use the mixer running in the middle and high grades, and it is easy to use the overspeed gear+high speed ratio configuration.

对于动力匹配的选择你们了解了吗？如果对此您还是有不理解的地方，欢迎来我们网站http://www.zkhntjbc.com进行咨询了解。

Do you understand the choice of power matching? If you still don't understand this, welcome to our website http://www.zkhntjbc.com Ask about it.