小型搅拌机的日常维护要点有什么呢？实际上为了更好更顺利更长久的使用该设备，就应该来了解这方面的信息，下面小编为您讲解七点。

What are the key points for daily maintenance of small mixers? In fact, in order to use the device more smoothly and for a longer time, you should learn about this information. Here are seven points to explain.

1、主机的光滑检查。在搅拌主机工作时,可查询光滑脂泵刮油器是不是在正常工作的刮油。

1. Smoothness check of the host. When the mixing host is working, you can check whether the grease pump oil scraper is working normally.

2、查询光滑脂泵压力表值正常状况下工作压力为10,压力若低于10可能为光滑脂泵泵芯梗塞,假如压力高于60可能为分配阀梗塞或许后边地管路梗塞。

2. Query the pressure gauge value of the smooth grease pump. Under normal conditions, the working pressure is 10. If the pressure is lower than 10, the smooth grease pump core may be blocked. If the pressure is higher than 60, the distribution valve may be blocked or the rear pipeline may be blocked.

3、在每个轴头有一个备用黄油嘴用手指甲压下黄油嘴的顶珠,如有光滑脂出,则证明轴头光滑到位,反之则证明轴头光滑不到位。

3. There is a spare grease fitting on each axle head. Press the top bead of the grease fitting with your fingernail. If there is any smooth grease, it means that the axle head is smooth and in place. Otherwise, it means that the axle head is smooth and not in place.

4、在自动出产状态下搅拌主机卸料门手入手柄应处于收回方位,且球阀处于中位,两个手自动改换螺堵应全部拧紧,防止手油泵过早损坏。

4. In the automatic production state, the manual inlet handle of the discharge door of the mixing host should be in the retracted position, and the ball valve should be in the middle position. The two manual automatic replacement plugs should be fully tightened to prevent premature damage of the manual oil pump.

5、搅拌主机减速箱应留意及时加油和换油检查齿轮油是不是满足,要保证可以查询其示油器的油位。

5. The reduction gearbox of the mixing host shall be filled and replaced in time to check whether the gear oil meets the requirements and ensure that the oil level of the oil indicator can be checked.

6、检查减速箱有无漏油的表象叫板主机减速箱易漏处为输入、输出轴封处,油温传感器处。

6. Check whether there is oil leakage in the reducer. The vulnerable parts of the reducer of the main engine are the input and output shaft seals and the oil temperature sensor.

7、搅拌轴、搅拌叶片每个工作周期应清洗,防止结料和抱轴。

7. The mixing shaft and mixing blade shall be cleaned in each working cycle to prevent material binding and shaft holding.

小型搅拌机的七点日常维护要点具体内容就到这里了，您对此有什么想法就来网站http://www.zkhntjbc.com咨询吧！

Here are the seven points for daily maintenance of small mixers. If you have any ideas, please come to the website http://www.zkhntjbc.com Consult!