小型搅拌机设备在长时间的使用中难免会存在一定的故障问题，为了避免设备在使用中的良好性能，就需要我们对设备进行合理的维修才行。那么设备在维修过程中存在哪些需要注意的事项呢？

It is inevitable that there will be some failures in the small mixer equipment in the long use. In order to avoid the good performance of the equipment in use, we need to carry out reasonable maintenance on the equipment. What should be paid attention to during equipment maintenance?

搅拌筒：在初次使用到50小时时，要及时检查罐体及其他部位螺栓是否有松动，每天行车前要检查托轮与滚道的润滑，每个月打开一次托轮护罩，清理内部的油污并添加润滑油脂。

Mixing drum: when the tank and other parts are used for 50 hours for the first time, timely check whether the bolts of the tank and other parts are loose. Before driving every day, check the lubrication of the supporting wheel and the raceway. Open the supporting wheel shield once a month, clean the internal oil stain and add lubricating grease.

液压驱动系统：液压系统是搅拌车的核心系统。为保证搅拌车能正常工作，搅拌罐能运转正常，须在每次车辆发动前检查油路散热器和减速机的液压油位，保证油位指示在视窗范围内。同时要保证它的清洁，不能让灰尘等污染系统液压油，造成系统不能正常工作或损坏。

Hydraulic drive system: the hydraulic system is the core system of the mixer. In order to ensure that the mixer truck can work normally and the mixing tank can operate normally, the hydraulic oil level of the oil radiator and reducer must be checked each time before the vehicle is started to ensure that the oil level indication is within the scope of the window. At the same time, ensure that it is clean, and do not allow dust and other pollutants to pollute the hydraulic oil of the system, causing the system to not work normally or be damaged.

供水系统：气压供水系统加水量好在水箱的四分之三处，经常检查阀体是否堵塞或是否有工作异常。在有结冰可能的环境中使用时，供水系统须排空存水，防止管路冻裂。

Water supply system: air pressure water supply system can add water at three quarters of the water tank. Check the valve body frequently for blockage or abnormal operation. When the water supply system is used in an environment with the possibility of icing, the water storage must be drained to prevent the pipeline from freezing.

还有一点不能用水直接冲洗小型搅拌机车身，搅拌罐车身内部机构是比较复杂的，凹槽、通孔设计比较多，一旦用水冲洗了，那么水分沉积在机身内不容易干燥，就容易使得零部件锈蚀。

Another point is that the body of a small mixer cannot be washed directly with water. The internal mechanism of the body of the mixing tank is relatively complex, and there are many grooves and through-hole designs. Once washed with water, the water deposited in the body is not easy to dry, and the parts are easy to rust.

小型搅拌机在维修中需要注意的事项就讲解到这里了，您对此有什么问题就来我们网站http://www.zkhntjbc.com咨询了解吧！

Here are the matters needing attention in the maintenance of the small mixer. If you have any problems, please come to our website http://www.zkhntjbc.com Ask and understand!