如果使用时间长，油封会磨损。方法：更换新油封即可。

If used for a long time, the oil seal will wear. Solution: replace the oil seal with a new one.

如果长期不换油，滤芯质量会变差，油会变得太脏，油封磨损会加快。方法：尽快更换液压油和滤芯。

If the oil is not changed for a long time, the quality of the filter element will become poor, the oil will become too dirty, and the wear of the oil seal will accelerate. Solution: replace the hydraulic oil and filter element as soon as possible.

传动轴失去平衡，剧烈振动，造成主轴摆动油封磨损。方法：及时修复和更换轴。

The transmission shaft is out of balance and vibrates violently, causing wear of the main shaft swing oil seal. Solution: repair and replace the shaft in time.

液压油变质和乳化，降低润滑性能并加速油封磨损。方法：尽快更换液压油和滤芯。在严重的情况下，需要对系统进行清洁。

The deterioration and emulsification of hydraulic oil will reduce the lubricating performance and accelerate the wear of oil seal. Solution: replace the hydraulic oil and filter element as soon as possible. In severe cases, the system needs to be cleaned.

泵支架松动，开泵，泵固定螺栓松动，造成整个液压泵振动，油封磨损。方法：经常检查并排除全自动上料搅拌叉车出现故障的可能性，防止和避免出现故障。

The pump support is loose, the pump is started, and the pump fixing bolts are loose, causing vibration of the entire hydraulic pump and wear of the oil seal. Solution: regularly check and eliminate the possibility of failure of the full-automatic feeding and mixing forklift to prevent and avoid failure.

自动混凝土搅拌机系统回油不良，回油管路和散热器堵塞，导致电机外壳压力升高和油封泄漏。方法：堵塞物，稳定回油回路。

The oil return of the automatic concrete mixer system is poor, and the oil return pipeline and radiator are blocked, resulting in the pressure rise of the motor housing and oil seal leakage. Solution: remove the blockage and stabilize the oil return circuit.

如果散热器不散热，油温会变得过高，粘度和润滑性会降低，油封会过热，油封无法工作。

If the radiator does not dissipate heat, the oil temperature will become too high, the viscosity and lubricity will be reduced, the oil seal will overheat and the oil seal will not work.

方法：散热器上的障碍物并冷却系统，以防止泵电机磨损。在严重的情况下，必须停止和停止发动机，并用水冲洗泵的电机和散热器外壳进行冷却。

Solution: remove the obstacles on the radiator and cool the system to prevent the pump motor from wearing. In severe cases, the engine must be stopped and stopped, and the pump motor and radiator housing must be flushed with water for cooling.

冬季运行时，由于预热不足，油温过低，油封、油封达不到理想的工作温度。对策：启动时停止油箱，怠速运转10～20分钟，待油温恢复正常后更换油箱。

During winter operation, due to insufficient preheating and low oil temperature, the oil seal and oil seal can not reach the ideal working temperature. Countermeasures: stop the oil tank when starting, idle for 10 ~ 20 minutes, and replace the oil tank after the oil temperature returns to normal.

自动混凝土搅拌机液压泵轴端油封易碎。严格遵守相关规定可以有效防止多次漏油。如果您遇到漏油，您需要冷静下来并确定问题的具体原因。

The oil seal at the shaft end of the hydraulic pump of the automatic concrete mixer is fragile. Strict compliance with relevant regulations can effectively prevent multiple oil leaks. If you experience an oil leak, you need to calm down and determine the specific cause of the problem.

自动混凝土搅拌机“挡油”现象的内容便是这样了，您可以关注我们网站www.zkhntjbc.com了解咨询更多相关事项！

This is how to solve the problem of "oil retaining" of automatic concrete mixer. You can follow our website www.zkhntjbc Learn more about consulting!