社会在不断发展，用到小型搅拌机的地方也越来越多，在农村，常见的就是小型搅拌机了，经常使用搅拌机发生故障也是常有的事情，关键是要找到发生故障的原因。

With the continuous development of society, there are more and more places where concrete mixers are used. In rural areas, small mixers are common, and failures of mixers are common. The key is to find the causes of failures.

1、小型搅拌机安装平稳牢固，行走轮要离开地面，机座要高于地面。

1. The small mixer shall be installed stably and firmly, the walking wheel shall be off the ground, and the base shall be higher than the ground.

2、小型搅拌机开机前电气设备良好，空转运行待机械运转正常后，再加料搅拌。

2. The electrical equipment of the small mixer shall be in good condition before startup, and the materials shall be added and mixed after the machine operates normally in idle mode.

3、操作中边加料边加水，不能加入料后再启动，投料不准超过额定容量。

3. During the operation, add water while adding materials. Do not start the machine after adding materials. Feeding must not exceed the rated capacity.

4、加料量，工具不能碰撞搅拌机，更不能在运转中把工具伸进搅拌机内扒料。

4. The feeding amount and tools shall not collide with the mixer, and the tools shall not be put into the mixer to pick up materials during operation.

5、料斗内不能进入杂物，杂物时须停机进行。

5. No sundries can enter the hopper, and the machine must be stopped to remove the sundries.

6、如果小型搅拌机作业中发生故障，应断电停机，查找原因，不得用工具撬动等危险方法，强行机械运转。

6. In case of failure in the operation of small mixer, power off and stop the mixer to find out the cause. Do not use tools to pry or other dangerous methods to force the mechanical operation.

7、进料口处须设置铁棚，使用时不能随意拆掉，拆除清理需要即时安装好，工作完毕，要将小型搅拌机清洗干净，清理时不得使电机及电器受潮。

7. The iron shed must be set at the feeding port, which cannot be removed at will during use. The removal and cleaning needs to be installed immediately. After the work is completed, the small mixer should be cleaned, and the motor and electrical appliances should not be affected with moisture during the cleaning.

如果有堵塞，就要在开机前清理。开机的时候计量称斗如果是空斗，显示器上须是0，如果没有显示0，可以按键将数字消去。更多相关内容就来我们网站http://www.zkhntjbc.com咨询吧！

If there is any blockage, it should be cleaned before starting the machine. When starting up, if the metering scale bucket is empty, the display must be 0. If no 0 is displayed, press the Clear key to erase the number. More relevant content will come to our website http://www.zkhntjbc.com Consult!