概述:小型搅拌机会在长期运行过程中自然升高温度,但是如果温度超过设备本身可以承受的温度,则会对设备造成一些损坏。因此,当设备温度过高时,我们需要进行相应的维护工作。让我们来看看
小型搅拌机会在长期运行过程中自然升高温度,但是如果温度超过设备本身可以承受的温度,则会对设备造成一些损坏。因此,当设备温度过高时,我们需要进行相应的维护工作。让我们来看看。
The temperature of small mixer will rise naturally during long-term operation, but if the temperature exceeds the temperature that the equipment can bear, it will cause some damage to the equipment. Therefore, when the temperature of the equipment is too high, we need to carry out the corresponding maintenance work. Let's see.
1,防止发动机过热:由于环境温度高,发动机容易过热。必须加强发动机冷却系统的检查和维护。这包括检查水箱,恒温器,泵,风扇等,并注意及时添加它们。注意冷却水。当水温超过100°C时,请停在阴凉处冷却,让发动机空转,然后打开引擎盖以帮助散热。
1. Prevent the engine from overheating: due to the high ambient temperature, the engine is easy to overheat. The inspection and maintenance of engine cooling system must be strengthened. This includes checking water tanks, thermostats, pumps, fans, etc. and adding them in time. Pay attention to the cooling water. When the water temperature exceeds 100 ° C, please stop in a cool place for cooling, let the engine idle, and then open the hood to help heat dissipation.
2,防止发动机爆燃:夏季气温很高,有时会超过35°C,并且在这样的季节,对于汽车的某些老化零件,自然爆燃的可能性要高得多。因此要做好预防工作。
2. Prevent engine deflagration: in summer, the temperature is very high, sometimes more than 35 ° C, and in this season, the possibility of natural deflagration is much higher for some aging parts of the car. Therefore, we should do a good job in prevention.
3,防止汽车漆面损坏:汽车漆面老化后,强烈的阳光照射下,会老化,起皱,普通的美容打蜡可以起到一定的防晒作用,但由于任何汽车蜡中都含有铋成分,长期紫外线会将该漆面生锈,留下一点黑点。车蜡本身并不能提高硬度和抗紫外线性,但是由于高温会很快消失。停车时,请注意将车停在阴凉处。
3. Prevent the damage of automobile paint surface: after the automobile paint surface is aged, it will age and wrinkle under the strong sunlight. Ordinary beauty waxing can play a certain role in sun protection, but because any automobile wax contains bismuth, long-term ultraviolet light will rust the paint surface, leaving a little black spot. The car wax itself can not improve the hardness and anti UV linearity, but it will soon disappear due to high temperature. When parking, please pay attention to park in the shade.
4,防止汽车轮胎爆裂:高温时,容易刺穿,温度过高时,轮胎容易变形,抗拉强度降低。由于轮胎本身不是标准气压,轮胎会老化,性能减弱,或者在行驶过程中轮胎滚动成硬质金属或其他硬物,从而导致汽车突然爆裂。
4. Prevent tire burst: it is easy to puncture when the temperature is high, and it is easy to deform when the temperature is too high, and the tensile strength is reduced. Because the tire itself is not the standard pressure, the tire will aging, performance degradation, or in the process of driving the tire rolling into hard metal or other hard objects, resulting in a sudden car burst.
5,防止发动机润滑:温度高时,机油粘度降低,导致润滑不良。因此,请务必检查机油的质量并及时添加或更换。注意及时清洁机油滤清器和散热器,以确保机油畅通,散热良好,并避免发动机过载。
5. Prevent engine lubrication: when the temperature is high, the oil viscosity will decrease, resulting in poor lubrication. Therefore, be sure to check the quality of the oil and add or replace it in time. Pay attention to clean the oil filter and radiator in time to ensure smooth oil flow, good heat dissipation and avoid engine overload.
6,防止刹车失灵:刹车液在高温环境下更容易蒸发汽化,在刹车油管中形成空气阻力,刹车蹄也容易烧蚀,导致刹车失灵。因此,有必要经常检查和调整制动系统。在长斜坡上,应注意停车制动器,以确保良好的制动性能。如果发现制动轮毂很热,请停止并冷却。
6. Prevent brake failure: the brake fluid is more likely to evaporate in high temperature environment, forming air resistance in the brake oil pipe, and the brake shoes are also easy to be ablated, leading to brake failure. Therefore, it is necessary to check and adjust the brake system frequently. On long slopes, attention should be paid to the parking brake to ensure good braking performance. If the brake hub is found to be hot, stop and cool.
只有这样,才能保证设备在正常运行中的良好性能,延长设备的使用寿命。我希望每个人都可以遵循它。掌握这些知识后,合理使用设备。
Only in this way can we ensure the good performance of the equipment in normal operation and extend the service life of the equipment. I hope everyone can follow it. After mastering these knowledge, use the equipment reasonably.