每次卸货后，用油罐车将水枪带到罐口，叶片，进料口，罐体和角处停止冲洗，以防止混凝土融化后积聚越来越多，不容易清算。将超过1立方米的纯净水添加到水箱中，并且地面旋转水箱主体停止洗涤。在操作过程中随时可以冲洗，并在关闭后彻底清理油轮。

After unloading each time, take the water gun to the tank mouth, blade, feed port, tank body and corner with the oil tank truck to stop flushing, so as to prevent the accumulation of more and more concrete after melting, and finally it is not easy to clear. More than 1 cubic meter of pure water is added to the tank, and the main body of the tank is rotated on the ground to stop washing. It can be flushed at any time during operation and cleaned thoroughly after shutdown.

混凝土搅拌机的给水过程：控制气压，固定接头。出厂时已设定好储罐气压。无需自己进行调整。如果有特殊情况需要自己调整，建议将气压控制在3.5mpa。

Water supply process of concrete mixer: control air pressure and fix joint. The air pressure of the tank has been set before delivery. You don't have to adjust yourself. If you need to adjust yourself in special circumstances, it is recommended to control the air pressure at 3.5Mpa.

由于原料的不同，每个托盘的混凝土质量略有不同。装载混凝土时，请务必检查其坍落度和连接的难易程度，并注意混凝土的早期熔融和混凝土分层，以防止将混凝土运输到现场。

Due to different raw materials, the concrete quality of each pallet is slightly different. When loading concrete, be sure to check its slump and connection difficulty, and pay attention to the early melting and stratification of concrete, so as to prevent the concrete from being transported to the site.

无法投入使用，破坏了人力和物力的时间。注意输送距离，这可能会导致混凝土的特性发生变化。将此距离控制在直径30以内。

It can not be put into use, which destroys the time of manpower and material resources. Pay attention to the conveying distance, which may lead to changes in the properties of the concrete. It is better to control the distance within 30 km in diameter.

在离开车辆之前，规划道路和混凝土搅拌机的交通状况，只是增加车辆在路上的时间。当遇到无法排放的人造或不可抗拒的元素时，请随时检查储罐中的情况。如果发现混凝土开始融化，则应立即排出材料，以免刮坏整个罐体。

Before leaving the vehicle, plan the traffic condition of the road and concrete mixer, just increase the time of the vehicle on the road. When encountering man-made or irresistible elements that cannot be discharged, please check the condition in the tank at any time. If it is found that the concrete begins to melt, the material shall be discharged immediately to avoid scratching the whole tank.